In Creo;

Open your Widget file, NOT your mould tool

File > Save As > Plastic Advisor – DO NOT select an injection point – choose Cancel in the Select window

Plastic Advisor will open in a separate window

First pick the Injection Point Location.

Then go to the Analysis Wizard, select Plastic Filling and pick Next.

There are various polymers used in LDS and it is unlikely they will be in the Specific Material list.  Chooses Next to set some basic parameters.

Choose Finish to run the analysis

 

Generic Polymer

Name: Exxon LDPE Escorene LD 605 BA

Suggested Melt Temp: 200 degC

Suggested Mould Temp: 30 degC

Melt Index: 6.5 g/10min

Density: 0.924 g/cm3